Mobile laptop cart and stand

SR-2026-058 · Furniture · Laptop cart · August 2026

A three-piece trial of a mobile laptop cart, ordered small because the client wanted the castor and brake quality checked before listing.

Receiving photographs

Photographs taken at our consolidation warehouse as the lot was received and checked. Container numbers, shipping labels, supplier marks and brand markings are masked; the lot is shown as it arrived, not restyled.

How this order was run

1. Booked production against the client's delivery date and worked backwards from the sailing, not forwards from the order.
2. Gave the lead time that was realistic for this category rather than the lead time that wins the order.
3. Released the lot only after the receiving set had been opened, counted and photographed, and sent the photo set out with the packing list.

What was checked at receiving

This is the laptop cart check sheet — the same list every order in this category goes through before the container is released.

• Panel thickness and edge banding measured against the approved sample — banding that lifts at a corner is the first thing to fail in transit
• Board moisture content read at incoming; panels above roughly 12% held back from the shipment
• One unit assembled out of the production flat pack, so hole positions and cam fittings are proven on production parts rather than on a pre-production sample
• Back panel, shelf pins, doors and drawers operated on every unit in the inspection set
• Surface inspected under raking light for sanding marks, scratches and colour variation across the lot

How it was packed

• Five-layer carton with corner protectors and edge foam
• Flat-packed where the design allows, to cut cube on the ocean leg
• Hardware bagged and taped to a marked panel so it cannot go missing in the box
• Carton marked with model, quantity and a handling pictogram set

The note

Board furniture fails at the joints and the edges. A unit that assembles cleanly on the factory floor can still split at a cam fitting after a month of container humidity — which is why the moisture reading and the edge banding check matter more than how the sample looked.

It is the reason this category is checked unit by unit rather than carton by carton: the defect that matters is inside the box, and it does not announce itself until the end customer is holding an Allen key.

Other records from the same belt