Office desk, gold frame with black top

SR-2026-048 · Furniture · Office desk · June 2026

Twenty desks in a gold-frame and black-top combination, ordered as a range extension alongside an existing chair line.

Receiving photographs

Photographs taken at our consolidation warehouse as the lot was received and checked. Container numbers, shipping labels, supplier marks and brand markings are masked; the lot is shown as it arrived, not restyled.

How this order was run

1. Worked the list back to the Foshan (Shunde / Lecong) factories that hold the tooling and the finish in house, and dropped two candidates whose quotes did not survive a price-pattern check.
2. Ran the first unit off the line through the full check sheet before bulk started, and corrected the packing rather than the product.
3. Held the balance of payment until the inspection set had been opened and photographed on our floor.

What was checked at receiving

This is the office desk check sheet — the same list every order in this category goes through before the container is released.

• Leg splay and twist checked with the unit standing on a flat reference — a table that rocks at the factory will rock on the client's floor
• Load applied to the top and to the apron joints, at the point where the leg meets the frame
• Finish checked on the top under raking light, and on the underside and inner faces where factories economise
• Glass and stone tops inspected for chips at the edge and measured for thickness before packing
• Height and footprint verified against the approved drawing, not against the catalogue photograph

How it was packed

• Top wrapped in foam and corner-boarded, boxed separately from the base where the design allows
• Legs and stretchers bagged with the hardware and taped inside the main carton
• Glass or stone packed in its own crate with a foam gasket on all four edges
• One carton per lot dropped and stack-tested before the container closes

The note

Tables fail on the top surface and on the leg joint. Both are visible on arrival and both are the client's most expensive complaint — a replacement top usually means a second shipment, not a second part.

It is why a table order is inspected standing up, on a flat floor, with the top loaded — the three things a factory photograph never shows.

Other records from the same belt