Dressing table with mirror

SR-2026-065 · Furniture · Dressing table · September 2026

Three dressing tables with attached mirrors — the mirror is the risk, because it travels in the same carton as the frame.

Receiving photographs

Photographs taken at our consolidation warehouse as the lot was received and checked. Container numbers, shipping labels, supplier marks and brand markings are masked; the lot is shown as it arrived, not restyled.

How this order was run

1. Quoted against the Foshan (Shunde / Lecong) makers that actually run this category, then visited the shortlist before sampling — a quote that looks too low is usually a trader, and a visit settles that faster than any document check.
2. Set the standard on a production sample rather than a catalogue image, and photographed it, so both sides were judging the same physical unit.
3. Booked the receiving inspection against the production calendar rather than the ship date, so there was still time to rework instead of negotiating a discount.

What was checked at receiving

This is the dressing table check sheet — the same list every order in this category goes through before the container is released.

• Leg splay and twist checked with the unit standing on a flat reference — a table that rocks at the factory will rock on the client's floor
• Load applied to the top and to the apron joints, at the point where the leg meets the frame
• Finish checked on the top under raking light, and on the underside and inner faces where factories economise
• Glass and stone tops inspected for chips at the edge and measured for thickness before packing
• Height and footprint verified against the approved drawing, not against the catalogue photograph

How it was packed

• Top wrapped in foam and corner-boarded, boxed separately from the base where the design allows
• Legs and stretchers bagged with the hardware and taped inside the main carton
• Glass or stone packed in its own crate with a foam gasket on all four edges
• One carton per lot dropped and stack-tested before the container closes

The note

Tables fail on the top surface and on the leg joint. Both are visible on arrival and both are the client's most expensive complaint — a replacement top usually means a second shipment, not a second part.

It is why a table order is inspected standing up, on a flat floor, with the top loaded — the three things a factory photograph never shows.

Other records from the same belt